Bass Gain
Current Bass amplification for the current channels as set by encoder 1 (B). Adjustable between
-12 dB and +12 dB in steps of 0.5 dB.
Bass Freq
Corner frequency of the shelf
bass filter. Adjustable from 20 Hz
to 150 Hz in steps of 1 Hz. De-
fault: 85 Hz.
Bass Q
The quality factor of the filter is
adjustable from 0.5 to 1.5. De-
fault 0.9.
Band 1-5 Gain
Available settings are -12 to +12
dB in steps of 0.5 dB.
Band 1-5 Frequency
Adjustable from 20 Hz (200 Hz bands 4/5) to 20.0 kHz, in steps between 1 Hz and 100 Hz.
Band 1-5 Q
Quality factor is adjustable from 0.5 to 9.9 in bands 1 to 3, and 0.5 to 5.0 in bands 4 and 5, in
steps of 0.1 dB. This equals a bandwidth setting of 2.54 (0.5), 0.29 (5.0) and 0.146 (9.9).
Treble Gain
Current Treble amplification for the current channels as set by encoder 2 (T). Adjustable between
-12 dB and +12 dB in steps of 0.5 dB.
Treble Freq
Corner frequency of the shelf treble filter. Adjustable from 3 kHz to 10 kHz in steps of 100 Hz.
Default: 6.5 kHz.
Treble Q
The quality factor of the filter is adjustable from 0.5 to 1.5. Default 0.7.
Dual EQ
OFF or ON. Default: OFF. When set to ON, the 5-band parametric equalizer can be set individu-
ally for left and right channel.
B/T Enable
OFF, ON. Default: ON
B/T Load with EQ
The current B/T setting is always stored with the EQ Preset, but only loaded (automatically set
and activated) when this option has been set to ON. The Bode plot then shows the effect of the
B/T setting as well, and Bass and Treble controls are added as bands BB and BT for direct control
within the graphical EQ screen, turning the 5-band PEQ into a 7-band one.
Band 1 Type
Available settings are Peak, Shelf, High Cut and High Pass (Low Cut). All filters are adjustable
from 20 Hz to 20 kHz, at a Q of 0.5 to 9.9. Cut/Pass have a fixed 12 dB/oct filter steepness.
Band 5 Type
Available settings are Peak, Shelf or High Cut. High Cut is adjustable from 200 Hz to 20 kHz, at
a Q of 0.5 to 5.0 and a fixed 12 dB/oct.
To Next Page
Loading...