Need help?Do you have a question about the RMS PM401R and is the answer not in the manual?
Controls the volume of each individual channel to blend into the total output.
Controls the amount of volume sent to monitor outputs.
Controls the amount of reverb or effect to modify channel sound.
Adds or reduces the blend of Hi and Low frequencies for each channel.
1/4" standard input connector for balanced and unbalanced inputs.
Low impedance XLR input for microphones.
Sends power for condenser microphones through XLR connector.
Provides tonal shaping by adjusting high, middle, and low frequency bands.
Controls the master volume level of the power amplifier section.
1/4" output for connecting monitor signal to external amplification unit.
Connects external effect unit to your powered mixer.
RCA connectors for recording, playback, and level control.
1/4" jack and level control for monitoring mixer output.
1/4" connectors for connecting speakers to the unit.
Protects unit against power surges; must be replaced with identical value.
To Next Page
General