HOWTO: Waste Water Dumping
110
© 2014 by Roadtrek, Inc.
Rubber doughnut installed on nozzle
•• Open the valve on the end of the sewage discharge hose.
•• Insert the waste water discharge hose outlet into the dump
station waste receptacle.
•• There are two ways to secure the hose in the dump station
waste receptacle four inch pipe. In the white box that came
with your Roadtrek there is a rubber doughnut, which goes
over the discharge nozzle and can be wedged into the waste
receptacle to hold the waste water discharge hose in place.
Some RV parks require you to use a doughnut. If you trust
gravity more than friction, or don't want to store the doughnut
between uses, use a rock to weight the hose down. Either way,
make sure the hose doesn't get loose when you turn the pump
on.
The discharge stream is forceful and will knock the hose
out of the drain if you do not weight it down or secure it in
the drain with the doughnut. It is much easier and more
sanitary to secure it before turning the pump on than it is to
chase it around afterwards.
To Next Page
Loading...
