HOWTO: Summer and Winter Mode
127
© 2014 by Roadtrek, Inc.
•• Run the water pump briefly to drain water from the water line to the exterior tank, then switch the tank selector valve from
the exterior to the interior tank.
Tank selector valve in exterior tank
position (colored plastic handle pointed
toward driver's side of Roadtrek). This
valve is located inside the enclosure
under the side bench, just in front of the
tank isolator valve.
Tank selector valve in interior tank
position, with the colored plastic handle
pointed up.
•• Open the lid on the side bench enclosure by removing the side bench's cushion and table to expose the hinged lid. Undo
the Robertson head screw to raise the lid. Once you know where these valves are you can just open the access door on the
front, but it's best to unscrew the top to give you a full view if you're not familiar with these controls.
To Next Page
Loading...
