Sleeping Facilities
21
© 2015 by Roadtrek, Inc.
•• Push down and hold the bottom part of the switch until the sofa is completely flat.
Twin beds King bed
Twin Beds
You create two twin beds by lowering the sofa. The sofa makes a continuous sleeping surface with the two bench seats,
leaving the center aisle to make it easy to get in and out of bed.
King Bed
Once the sofa has been lowered fully, please use the following steps to make create a king bed configuration.
• Locate the panel under the bench cushions on the passenger’s side, and slide it out into the open space between the two
side bench seats. Secure it into the notches on the inner surface of both bench seat bases.
•• Reposition the bottom cushions of the side bench seats over this panel so they are side by side.
•• Place the long thin vertical bench seat cushions in the empty space between the wall and the larger bench seat cushions.
When you raise the sofa put the seat belts back in position. To do this, open the back door of the vehicle and push
the seatbelts through the sofa between the seat and back cushions. NEVER use the rear seats for passengers without
seatbelts.
To Next Page
Loading...
