Utilities
42
© 2015 by Roadtrek, Inc.
City Water
Your Roadtrek can operate in either fully self-contained mode, or can be connected to a water supply such as a campsite's
faucet.
Campgrounds and municipalities vary greatly in supplied water pressure. Before connecting to external water
supplies, purchase and install a pressure regulator inline with the water connection.
You can always fill your tanks using the gravity fills and operate from the tanks if you are uncertain about the water
pressure at a location.
The city water inlet connection is located in the small compartment just in front of the driver's side rear tire.
Roadtrek recommends that you use a dedicated single purpose potable-water hose. These are usually white in color.
Buy a new one and use it only for filling your tanks and connecting to city water. View any hose lying around a
campground with extreme skepticism, especially it there's a wastewater dump nearby. Large RVs use hoses to flush
their wastewater system.
To connect the Roadtrek's water system to an outside source:
•• Turn the water pump off.
•• Close the city tank fill valve by turning the handle to the vertical (across the water line) position. This valve is behind the
black plastic radiator cover on the left side of the sliding side door step.
To Next Page
Loading...
