ROBBE SCHLUTER Ornith 46 User Manual

No. S 2500, S 2501
Ornith 46
Montage- und Bedienungsanleitung

ROBBE SCHLUTER Ornith 46 Specifications

General

Brand	ROBBE SCHLUTER
Model	Ornith 46
Category	Toy
Language	English

Summary

Specification

Notes on the radio control system

Details regarding radio control system setup and servo arm lengths.

Contents of the german building instructions

List of sections covered in the German building instructions.

Notes on the building instructions

Guidance on how building instructions are structured and interpreted.

Basic information on construction, notes on replacement parts

How lift is generated by the main rotor

Controlling a model helicopter

How the swashplate works

Mechanism of the swashplate in helicopter control.

Four primary functions have to be controlled

Overview of the four main control functions of a helicopter.

Stage 1: Installing the skid landing gear

Stage M1: preparing the glowplug motor

Stage M2: installing the glowplug motor

Stage 2: Installing the tail boom and toothed belt

Stage 3: stabiliser panels, tail boom braces and tail rotor pushrod

Stage 4: installing the servos

Stage 5: installing the pushrods

Stage 6: installing the receiving system

Setting up the radio control system

Setting up the servos for collective pitch

Adjusting servos for collective pitch movement.

Setting up the servos for roll and pitch-axis movements

Configuring servos for roll and pitch control.

Setting up the tail rotor servo

Adjusting the tail rotor servo for correct operation.

Checking the direction of gyro effect (sketch 1)

Verifying the gyro's directional response.

The throttle servo

Setting up the throttle servo for proper engine control.

Final checks

Throttle curves

Explanation of throttle curve programming.

Pitch curve

Explanation of collective pitch curve programming.

Adjusting blade tracking, (sketch 2)

General information on programming the radio control system

The basic requirement

Essential prerequisites for helicopter radio system setup.

Idle-up 1

Auto-rotation (hold-mode)

Standard values

Recommended default settings for auto-rotation.

Practical notes for the beginner to helicopter flying

The relationship between stick movements and helicopter movements

Mapping transmitter stick inputs to helicopter flight movements.

Pre-flight check-list, starting procedure

Maintenance, post-flight checks

Important

Critical maintenance tasks and lubrication points.

Locating and eliminating faults

The motor fails to start

Troubleshooting steps for a non-starting motor.

The motor turns over when the starter is operated, but fails to fire

Diagnostic guide for engine ignition failure.

The motor fires, but stops again immediately

Solutions for a motor that stops shortly after starting.

The motor runs, but the helicopter fails to lift off

Steps to diagnose and resolve lift issues.

Helicopter problems

The helicopter shakes and vibrates

Causes and solutions for helicopter vibration.

Note on replacing parts

And one final tip