Robe AT Series User Manual

28
Examples:
You wish to repeat steps from No.20 to No.25 three times:
Step: 25 Sce: 124 Step: 26 Sce: Loop
LStp: -- NLop: --- LStp: 20 NLop: 003
Prg.time: 320.0s Prg.time: 425.0s
Fati: 10 StTi: 20 Fati: -- StTi: --
You wish to repeat step No.25 ten times:
Step: 26 Sce: Loop
LStp: 25 NLop: 010
Prg.time: 439.0s
Fati: -- StTi: --
This setting repeats steps from No.20 to No.25 permanently:
Step: 26 Sce: Loop
LStp: 20 NLop: ---
Prg.time: 99999.9s
Fati: -- StTi: --
The FADE TIME and STEP TIME sliders are not active in these "Loop"screens.When the loop is running,the fade
and step times are used as were previously defined at each program step.
5.To save the program which has been created,press <ENTER> and the safety question appears:
Save changes ?
ESC/ENT
6.Press <ENTER> to save the program or press <ESC> to leave the menu without saving changes.
Deleting the program step
1.Use <UP>,<DOWN>or TILT wheel to select the program step which you want to delete.
2.Press <DEL>.The safety question appears:
Delete step ?
ESC/ENT
3.Press <ENTER> to remove the program step or press <ESC> if you do not want delete the step.
Example:You want to delete the step No.6.
Step: 05 Sce: 011 Step: 06 Sce: 012 Step: 07 Sce: 013 Step: 08 Sce: 014
LStp: -- NLop: --- LStp: -- NLop: --- LStp: -- NLop: --- LStp: -- NLop: ---
Prg.time: 40.0s Prg.time: 46.0s Prg.time: 52.0s Prg.time: 58.0s
Fati: 10 StTi: 30 Fati: 15 StTi: 60 Fati: 20 StTi: 60 Fati: 25 StTi: 60
I
Press <DEL> at step 6; the step sequences will change (the following step 7 will
become step 6):
Step: 05 Sce: 011 Step: 06 Sce: 013 Step: 07 Sce: 014 Step: 08 Sce: 015
LStp: -- NLop: --- LStp: -- NLop: --- LStp: -- NLop: --- LStp: -- NLop: ---
Prg.time: 40.0s Prg.time: 46.0s Prg.time: 52.0s Prg.time: 60.0s
Fati: 10 StTi: 60 Fati: 20 StTi: 60 Fati: 25 StTi: 60 Fati: 30 StTi: 80
Inserting the program step
1.Use <UP>,<DOWN>or TILT wheel until you reach the step prior to the one where you wish to insert the new
step.The inserted step will contain the same data as the current displayed step.

Robe AT Series Specifications

General

Brand	Robe
Model	AT Series
Category	Controller
Language	English