24
2) Pressing down on the
handles, turn the bowl
firmly in an anticlockwise
direction until it locks into
place.
3) Position the blade
mounted on the motor
shaft. Then rotate it so that
it is lowered right down to
the bottom of the bowl.
Always check that the blade
is correctly positioned at
the bottom of the bowl
before adding the ingre-
dients to be processed.
• If the lid parts are already assembled:
4) Place the lid assembly
in the correction position.
Next, insert the metal pin
as far as it will go.
5) Close the lid by
securing the locking hook
to the edge of the bowl
and pushing the handle
down.
The machine is now ready
for operation.
The green indicator light
should be on.
• If the lid parts have not been assembled:
4) Position the end of the lid arm in the hinge. Next,
insert the metal pin as far as it will go (photo 1). Push
the lid guide through the lid arm hole and screw the
cone into the top of the guide (photo 2). Clip the lid
onto the guide and turn it so that the dimples are
beneath the lid arm (photo 3).
• BLADE (see diagram, page 9)
For fine stuffing, mousse and emulsions, use the
smooth blades.
There should not be any rings between the base of the
blade holder and the lower blade.
You must always insert the small ring between the
blade holder base and the lower blade (bowl base
assembly) before carrying out mincing tasks. In order
to control the mincing process and prevent the meat
from overheating, always use the «pulse» switch
(coarse mincing assembly).
For grinding or kneading, use serrated blades and do
not fit any rings between the lower blade and the base
of the blade shaft.
Use fine serrated blades to chop parsley and do not
insert any rings between the blade holder base and
the lower blade.
1 2 3
WARNING
There is a green safety indicator light on the
control panel of the motor unit. If this green light
does not come on, consult the relevant paragraph.
A flashing green light means that the conditions
for the safe operation of the machine have not all
been met. Check that the bowl, lid arm and lid
are all correctly positioned. As soon as the light
stops flashing and stays on, you can use your
machine.
To Next Page
Loading...
