Robstep X1 Series - Operation and Safety; Assembly and Starting Procedures

To Next Page

To Previous Page

3. Operation of Robstep X1 and

safety notice

3.1 Operation description

Please read this manual carefully before

using.

• Please assemble Robstep X1 correctly

and fully charge the battery before use.

• Before driving, user should fully gen up

the driving environment.

• Please do not war sharp objects to avoid

injury during driving.

• Please do not drive on wet and slippery

ground.

Step 1: Take Robstep X1 frame and

parts out of the package.

Step 2: Robstep X1 electric bicycle

assembly

1. Let the power wire located at lower

telescopic rod go through the upper

telescopic rod.

2. Press the metal marble and make it be

in alignment with the groove inside the

lower telescopic rod, and then insert

the upper telescopic rod into the lower

telescopic rod.

Power wire

Upper telescopic rod

Lower telescopic rod

Metal marble