4. Maintenance of Robstep X1
User needs to conduct routine maintenance
for Robstep X1. This chapter mainly
introduces some maintenance tips.
• Before conducting below operation,
ensure the power supply and the
charging cable are disconnected. When
power is on or the battery is under
charging, the following operation is
• Inspect regularly on screws of front and
rear tires to see if they are tightened.
• Check the outer tires tread to see if there
is any abrasion and crack. If the tires
are worn, please contact Robstep or its
• Inspect regularly on screws of Robstep
X1 if they are tightened. If they are loose,
• Before using, please check to confi rm the
folding button is buckled up.
• Check regularly to see if there is any
broken parts. For any replacement,
please contact Robstep or its appointed
• For safety, if the battery reaches to 600
cycles, please return for inspection.
• Please use neutral detergent on Robstep
X1, wipe with a cloth, and then clean
• Do not spray water or other liquid
on Robstep X1 as to protect internal
electrical components and circuits from
• Lift and put down Robstep X1 with
• Make sure Robstep X1 is not connected
with the charger and is in power off
• Lift with two hands at the middle of
Robstep X1 for handing. Please do not
use the handlebar as the main force.
• Please store Robstep X1 indoors with
dry and suitable temperature. If it isn’t
used for a period of time, please do not
connect it with power supply.
• User should not open internal circuit or
• Modifi cation voids warranty.
• User should store Robstep X1 with a fully
charged battery, if not using for a long
period of time. And the battery should be
charged every three months.
To Next Page
Loading...