Need help?Do you have a question about the Robus Vantage 3 Series and is the answer not in the manual?
General| Brand | Robus |
|---|---|
| Model | Vantage 3 Series |
| Category | Camera Accessories |
| Language | English |
Securely seat your camera, lens, or head flush with the baseplate.
Use the included hex key to tighten the set screw from the bottom of the baseplate.
Turn twist-locks clockwise to extend sections and counterclockwise to tighten.
Unscrew the rubber foot and screw in the spike foot using a hex key.
Use the wrist strap to further stabilize and secure the monopod in your hand.
The integrated belt clip attaches the monopod to your waist for hands-free transport.
Loosen the set screw with the included 2 mm hex key.
Unscrew the baseplate, remove the mounting screw, and switch it to the other side.
Screw the baseplate back securely and tighten the set screw from the top.
Details maximum load, height, folded length, leg sections, and weight for RCM-633.
Details maximum load, height, folded length, leg sections, and weight for RCM-439.
Product is warranted against defects for ten years; details limitations and exclusions.
Contact Customer Service for RMA, return defective product with proof of purchase.
To Next Page
