Hardware Installation
1. SIM Card Installation. Loosen the screws associated with the cover by using a screwdriver and then find the
SIM card slot/Micro SD card slot. Press the card with finger until you hear a click and then tighten the screws
associated with the cover by using a screwdriver. Put back the cover and tighten the screws associated with
the cover by using a screwdriver.
2. Antenna Installation. Rotate the antenna into the antenna connector accordingly.
3. Terminal Block Installation. Insert the terminal blocks into the interfaces connector, then can connect the
devices or sensors to the gateway via corresponding interfaces e.g. RS232/RS485, DIDO...
4. Mounting Kit installation. (Optional)
Wall mounting DIN rail mounting
To Next Page
Loading...
