18
Start-up process and Setup Wizard
After you insert a new battery, your pump immediately performs
a self-test. Check the display and the beeps and vibrations to be
sure that your pump is working properly.
If anything in the self-test does not seem to work properly
contact your local pump support.
The start-up process is dierent when you:
j Start your pump for the first time
j Start your pump after it has been out of power for more than
10 hours
j Insert a new battery while the pump is in RUN mode
You will learn more about this in the following chapter.
Note
If you do not press o, x or z key for
more than 30 seconds, these keys will be
locked.
Press x and then z, or z and then x, to
unlock the keys to continue the programming.
You can adjust the time before the Key
lock engages. See chapter8.3.3, page109.
To Next Page
Loading...
