9 • Initial Startup
106
9.2 Installing or replacing the battery pack
When shipped, the battery pack is not installed in the
Accu-Chek Inform II meter.
After installing a new battery pack, the meter should
be charged for two hours in the base unit before
testing.
Whenever the meter is in the base unit, the icon
is displayed. This icon shows that power is available
and the meter can charge, if necessary.
Make sure that the allowable temperature range for
charging the battery pack (3-40 °C or 37-104 °F) is
maintained during installation and initial setup.
Replace the battery pack within approximately
10 minutes to retain the date and time settings.
Beyond this period of time, you may have to re-enter
date and time.
To Next Page
Loading...
