10 • Maintenance and Care
138
Cleaning the code key reader The code key reader should be cleaned as necessary.
1 Wipe over the surfaces with a clean and soft lint-
free cloth slightly dampened with water (wring out
any excess).
2 Dry the code key reader with a dry cloth or gauze
and visually verify that it is completely dry and no
moisture is left on the surfaces after cleaning.
Cleaning the Accu-Chek
Inform II Base Unit Hub
The hub should be cleaned as necessary.
1 Unplug the power supply unit and detach all other
cables from the hub before cleaning.
2 Wipe over the surfaces with a clean and soft lint-
free cloth slightly dampened with water (wring out
any excess).
3 Dry the hub with a dry cloth or gauze and visually
verify that it is completely dry and no moisture is left
on the surfaces after cleaning.
NOTICE
Do not wipe the electrical connectors at the back of the
hub. Avoid getting liquid into any opening otherwise it
could damage the electronic components.
To Next Page
Loading...
