Troubleshooting • 11
151
Meter reset A meter reset should only be performed if all other reme-
dies have failed.
1 Place the meter on a level surface.
2 Press the On/Off button for at least 12 seconds.
■ The meter powers off and on again.
■ The Roche logo is displayed.
If the Roche logo does not appear within 60 seconds,
place the meter in a base unit for a minimum of
15 minutes to recharge the battery.
■ The meter performs a system check. During the
system check, the Versions screen appears for a few
seconds, then disappears. The Versions screen
shows the version numbers of the meter compo-
nents. (The Versions screen shown here is for illus-
tration purposes only. Version numbers on your
meter may differ.).
■ A message appears informing you that the date and
time settings have been lost due to the meter reset.
3 Confirm the message Loss of Date/Time.
Kernel:
RootFS:
App:
Boot:
Build: 04.00.00
Versions
04.00.00
02.05.00
02.05.00
02.05.00
Checking system...
Performing self-checks...
Performing self-checks...
W-1302: D/T settings lost
due to meter reset or loss of
power. Enter D/T manually,
then synchronize meter or
see System Administrator
before performing further
tests.
Loss of Date/Time
To Next Page
Loading...
