Powering Up and Entering an Operator ID • 2
37
If wireless connectivity is activated, the (RF OFF)
icon is displayed as a button in the Power Up screen.
■ To temporarily disable the wireless network con-
nection, touch (RF OFF) in the Power Up
screen. The icon then changes to (RF ON).
■ To temporarily enable the wireless network con-
nection, touch (RF ON) in the Power Up
screen. The icon then changes to (RF OFF).
The RF ON/RF OFF button always displays the option you
currently have. The current communication status is dis-
played in the status bar (bottom line) of the display in all
menus and screens.
■ The icon is displayed, if wireless connectivity is
enabled.
■ The icon is displayed if the last attempt to com-
municate with the data management system was
successful and was terminated according to the
communication protocol.
■ The icon is displayed if the last attempt to
communicate with the data management system
was not successful or was unintentionally termi-
nated. If this icon persists, contact your system
administrator. Ignoring this information may lead to
a Download Lockout (if configured, see page 41).
Closing startup Once you have completed all the necessary changes,
■ touch to proceed to the screen used to enter
the operator ID, or
■ wait 5 seconds and the meter automatically pro-
ceeds to the screen used to enter the operator ID.
Contrast
Power Up 12:48 pm
09/18/13
Contrast
Power Up 12:48 pm
09/18/13
To Next Page
Loading...
