Patient Glucose Testing • 3
47
Confirming or selecting the test
strip lot
Once you have entered and confirmed the patient ID, you
are asked to choose the lot number for the test strips.
Compare the number displayed by the meter to the
number on the label of the test strip vial.
1 Select the lot number as follows:
■ If you want to use the preselected lot number dis-
played by the meter, touch to confirm.
■ To use a different lot number than the one dis-
played, touch to display a list of stored lot
numbers. Select the desired lot number from the
list.
■ To read the lot number from the test strip vial via
barcode scanner, press and release . Follow
the instructions for scanning IDs (see note below).
2 Touch to confirm the selected or scanned lot
number.
For additional information about storing lot numbers for
test strips, see page 73.
The meter can be configured so that manual
confirmation is not necessary. In this setup, only the
lot number is displayed. Additional options are not
available.
The meter can be configured so that lot numbers are
entered via barcode scanner only (see note below).
Note: Barcodes on control solutions may not be avail-
able in all countries. In this case either
■ manually enter the lot number each time
(recommended),
■ pick a previously entered lot number from the list,
or
■ configure the meter to only display the lot number
(without confirmation by the operator).
Patient Test
Patient 123456789
Use Strip Lot
12:48 pm
09/18/13
123456?
Strip Lots
344789
545794
545777
344654
12:48 pm
09/18/13
To Next Page
Loading...
