Roche Accu-Chek Instant - Connecting to a PC; USB PC Connection Guide

22
6
Connecting to a PC
Connecting the Meter to a PC
Using a USB Cable
Follow the steps below to access diabetes
management software on a PC. You can
use this software to view stored results,
set the meter time and date, and change
the target range.
1
Plug the small end of
a USB cable into the
meter.
2
Plug the large end of
a USB cable into a
USB port on the PC.
If the meter is o, it
turns on.
3
Start the diabetes management
software and initiate a data transfer.
4
The meter transfers
the data to the
software.
NOTE
The USB cable does not charge the
meter batteries. Remove the USB cable
after you have finished.
82688_09291423001_01.indd 2282688_09291423001_01.indd 22 8/20/2020 1:58:54 PM8/20/2020 1:58:54 PM