CoaguChek XS System User Manual for Self-Testing, version 10.0 USA
29
The Meter’s Display
The meter performs an automatic display check
when it is turned on. In case you suspect the display
or parts of it to be defective (e. g. if you have
dropped the meter), you must check by means of the
display test if the meter display works properly. If
your display is not functioning properly, do not
perform further tests as results may be misread if a
segment is missing. Contact the Roche Customer
Support Center at 1-800-428-4674 in this case.
If the display check is too
quick, you can put it “on
hold” by pressing and
holding down the On/Off
button the next time
you turn the meter on. For
as long as you keep the
button pressed, the
display remains frozen.
The full display should
appear as shown at left.
To Next Page
Loading...
