Roche Cobas 4800 System - Page 107

cobas® 4800 System 6 Maintenance
Systern Manual Instrument maintenance
Roche Diagnostics
A Initialization/waste block
B Waste bag or waste chute
Figure 6-1 Removing waste bag or waste chute
7
When replacing the small
waste bag, place the bottom portion of the waste bag
inside the support frame,
fold the top over the frame and then place the support
frame into the
initialization/waste block. Dispose of either waste bag and contents
according
to the
appropriate
local regulations.
Replacing large waste bag
1f a waste container is used remove the large waste bag from the waste container
and replace it with a new one. Close the large waste bag with a binder and dispose
of either waste bag and contents according to the appropriate local regulations.
• The waste chute and waste box need
to
be replaced when full and cannot
be
reused.
• 1f required, replace the waste chute in the same way as the small tip waste bag.
• 1f required, fold up a new waste container as indicated in Figure 3-12 Folding up a
new
waste box
(p.
49)
C Tip eject plate
D Support frame
System Manual . Version 1.0
107