Part B - System description cobas p 512
2-88 Operator's Manual - Version 1.6 - 10/2015
2.7.14 Maintenance menu – Date, time, day
This program is used to set the date, time and weekday in the system.
As a precaution, the system automatically checks the entries in the 'Date' and 'Day of the
week' fields. If date and weekday do not match, an error message is displayed on the status
line below. The entries will then have to be corrected.
Figure 2-64: Maintenance menu – Setting date, time and day of the week
NOTICE
On systems equipped with QS I module, the QS I computer's clock will synchronize itself with the
one of the QNX PC during the system's boot sequence.
In consequence, you need to reboot the system whenever you've changed these settings.
Enter the current date in this field (format: DD.MM.YYYY).
Example: 14.01.2008
Enter the current time here (format: HH:MM (24h)).
Example: 09:16
Once you move the cursor onto this array, a selection list with all allowed
entries will be shown.
Select the weekday matching the entered date and press the [PAGE DN] key in
order to save your entries. (This selection can also be made by means of the
cursor keys and the [ENTER] key.)
NOTICE
When trying to save a date that does not match the selected day of the week, you will be asked again
to select the correct one.
To Next Page
Loading...