Urisys - Operator’s Manual V.
. Data Transmission to a PC or Host Computer
In unidirectional mode, the results are transmitted immediately together with the sequence number, Patient ID (if
entered), date and time.
In bidirectional mode, transmission can only be accomplished by using the “Send” function when “MEMORY” is
displayed. If a bidirectional PC/host communication link cannot be established, the Urisys system aborts transmission
after several attempts and reports an “INTERFACE ERROR !” (see Section ).
In ASTM mode the results, sequence number, Operator ID, Device ID, Patient ID (if entered), date and time of the
measurement, and of the last calibration will be sent to the host.
For further information on the serial interface, refer to Section ..
ATTENTION: Ensure that all required data is backed up on a regular basis.
To Next Page
Loading...
