Roche Diagnostics
Urisys 1100® · ≥5.7 · Operator's Manual · 9.0
20 4. Software
As soon as Yes has been pressed to confirm a parameter
as the first item, the second item is shown with 2.
PARAM.: followed by the next, not yet confirmed, test
strip parameter. Press Yes or No to select the parameter
as the second item in the patient report, and so on.
If there are any test strip parameters that are to be
suppressed in the patient report, terminate selection
following the most recently confirmed parameter by
pressing “START”.
You can undo the selection by pressing the Default
function key when the display shows SEQUENCE
PARAMETERS. The Urisys 1100
®
system always
measures and memorizes all of the parameters on
whichever test strip is used. If, after reading, you wish to
reset the choice of parameters to the standard setting,
you can reinstate the complete report through the
MEMORY > Print or MEMORY > Send menu.
Date/time For setting the date and time.
The factory default is the date in Day-Month-Year order
and the time in hours (24-hour system) and minutes. If
required, the time can be displayed in the “12-hour plus
a.m./p.m.” system. Pressing the Sequence key allows the
date format to be changed to Month-Day-Year or Year-
Month-Day. Set causes the date and time to be displayed
and set. Pressing the left function key (<<<) moves the
blinking cursor to the left. The time or date unit
highlighted by the cursor can then be increased or
decreased by pressing the keys (+ / -).
q Pressing the START button confirms the setting,
closes the submenu, and resumes Ready-to-Measure
status.
To Next Page
Loading...
