General Overview
17
A
A
2.4.3 Software Setup
Either a service operator or a regular operator can access the menu for software setup.
This menu enables the operator to
䉴 set the time and date
䉴 preset the location (folder) where all generated data will be saved
䉴 enter a laboratory name
䉴 choose the types (and loudness) of alarm sounds the instrument will generate
䉴 manage the list of operators that have access to the instrument
䉴 specify the types of sample materials to be handled with the instrument
Note: The type of sample material used for a purification run can be selected later on
during Sample Ordering 2 (see chapter B for details). It is used for documentation pur-
poses only and does not influence the purification protocol.
Action Software Screen
Turn on the MagNA Pure Compact Instrument by pressing the Power On button
on the front of the instrument.
During initialisation/self test of the system components the start-up screen
appears.
The MAIN MENU Screen appears
Touch the SETUP Button on the touch-screen
The SETUP Screen appears
Note: Touch the Back button
(at the lower right corner of the
SETUP Screen) to return to the
MAIN MENU Screen.
Touch the SETTINGS Button
The SETTINGS Screen appears.
Note: Touch the Back button (at the lower right corner of the SETTINGS Screen)
to return to the SETUP Screen without changing any of the current settings.
1
2
3
4
5
6
7
Installation of the Instrument
Setup
MagNA Pure Compact Manual.book Seite 17 Dienstag, 28. Februar 2006 4:16 16
To Next Page
Loading...