Rock Solid Wholesale RS2200 - Product Cleaning and Maintenance; Problem Solving; Technical Data

6. Product cleaning and maintenance
Make sure the power is off. The machine can be cleaned with a warm, damp cloth
with detergent. Make sure the machine is completely dry before turning it on again.
Attention:
Be sure not to use benzene, thinner, ethyl alcohol, gasoline etc. which can result in
hazardous fumes, fading of the paint or corroding of the inner parts.
If the machine is not used for a long time, cover it to prevent dust from entering the
machine.
7. Problem solving
Malfunction
Possible reason
Solution
1
Lights are off
Is power supply ok?
Plug in again
Power switch of the appliance off
Turn off to on
Transient current too strong,blown
fuse
Change a new fuse
2
Noise
Is the foot screw level with the
floor?
Adjust foot screw
3
Remote control does not
work
No battery / battery empty
Replace battery
Too far from the machine
Valid range is 2.5M
4
Machine stops while in
use
Machine is overheated
Start again after 10
minutes
5
Does not work as
intended
Received too many commands
Turn off power and
restart
If you still can’t solve the product problem after reading the above-mentioned
content, please contact Rock Solid Wholesale for service. 1-888-476-9995
8. Technical data:
Rated voltage: 220-240VAC Frequency: 0-30HZ
Speed range: 0 to 99 levels
Power: 500W
Amplitude: 0-12 mm
Max Loading: 150kgs / 330lbs