Rockboard MOD 1 User Manual

All the connections of the MOD 3 are being covered by the above points.
MOD 3 Connections:
MOD
3
AC IEC
Input
3x TRS In/OutputAC IEC
Input
2x XLR
Output
XLR
Input
3x TRS In/Output 2x XLR
Output
XLR
Input
1. Let’s say you have an amp with an FX loop you’d like to utilize for your fancy Delay and send out a dry signal to FOH,
then this is what your setup might look like.
Instrument Input
Amp Input
Amp FX Send
Amp FX Return
Input Amp Footswitch
DI-Out to FOH
1
ST
pedal of signal chain
Last pedal of signal chain (front end)
DI-Out to FOH
Footswitch Amp
1st pedal for FX Loop
Last pedal for FX Loop
Examples
And here the connections unique to MOD 2:
• MIDI Thru: These two allow you to route MIDI commands to and from your pedalboard via an audio interface to your PC or Mac.
You can Program setups and scenes comfortably from your workstation and load them into your MIDI capable devices
on your RockBoard®.
• USB Thru: Just like with MIDI, you can control and save/load presets without removing your FX pedals from your board.
MOD 2 Connections:
MOD
2
4x TRS In/Output MIDI
Thru
AC IEC
Input
4x TRS In/OutputUSB
Thru
AC IEC
Input
MIDI
Thru
USB
Thru

Rockboard MOD 1 Specifications

General

Brand	Rockboard
Model	MOD 1
Category	Control Unit
Language	English