Rockler Lift FX User Manual

Router Lift FX
Setup Instructions
Congratulations on the purchase of your Rockler Router Lift FX! It makes it quick and easy to precisely
set the cutting height of your router bit from the top of the table. For safe and effective installation and
operation, please read the instructions fully before starting.

Rockler Lift FX Specifications

General

Type	Router Lift
Material	Aluminum
Compatibility	Most routers
Base Plate Size	9 1/4" x 11 3/4"
Plate Dimensions	9 1/4" x 11 3/4"

Summary

Installing the Router

Positioning the Router Motor

Setting the router motor upside down and aligning it with the center hole for proper installation.

Securing the Router Motor

Inserting the router into the carriage and adjusting the cam lock clamp for a secure fit.

Table Opening Requirements

Fitting the lift into router table openings and options for custom table applications.

Using the Router Lift FX

Adjusting Router Bit Height

Using the crank handle to raise or lower the router bit and understanding revolution adjustments.

Handle Removal Safety

Removing the crank handle after achieving desired height for safety and storage.

Re-adjusting Thread Tensioning

Thread Tension Adjustment Procedure

Steps to reset thread tension, including loosening nuts, adjusting the collar, and tightening.

Important Safety Instructions

General Safety Precautions

Guidelines on tool modification, reading manuals, user responsibility, and general workshop safety.

Personal Protective Equipment

Requirements for safety glasses, hearing protection, and appropriate attire.

Operational Safety Practices

Advice on alertness, avoiding impairment, tool usage, and awareness of surroundings.