Rockwell Automation Publication 1715-UM001J-EN-P - December 2020 157
Chapter 6
Configure the Redundant I/O System
Now that the hardware portion of the system is installed, you can configure
your 1715 Redundant I/O System by using the software applications that you
installed from the Product Compatibility and Download Center at
rok.auto/pcdc
. See System Software on page 59.
Before You Begin Before you begin configuring the 1715-AENTR modules in the redundant
chassis, verify that these tasks have been completed:
• Make sure that RSLogix 5000® programming software, version 20 or
later, or Studio 5000® environment, version 21 or later, is installed.
• Make sure that the drivers are installed by using RSLinx® Classic
software, version 2.57 or later.
• Make sure that the firmware is at the latest revision and the software is at
the latest version.
• Make sure that both Add-on Profiles are installed on your system:
- One for the 1715 adapter
-One for the 1715 I/O modules
Install the Software Install the following software:
• RSLogix 5000 programming software, version 20 or later, or Studio 5000
environment, version 21 or later
• RSLinx® Classic software, version 2.57 or later
Install the Add-on Profiles You must install two Add-on Profiles — one for the adapters, version 2.01.014
or later, and one for each of the I/O modules, version 3.01.014 or later. (The four
I/O module Add-on Profiles are contained in one file.)
Topic Page
Install the Software 157
Install the Add-on Profiles 157
Create the Project in RSLogix 5000 or Studio 5000 Logix Designer 160
Add the 1715-AENTR Adapter to the I/O Configuration Tree 165
1715-IB16D Digital Input Module 177
1715-OB8DE Digital Output Module 185
1715-IF16 Analog Input Module 189
1715-OF8I Analog Output Module 193
To Next Page
Loading...
