Rockwell Automation Allen-Bradley 1715-OB8DE - 1715-OF8 I Analog Output Module

Rockwell Automation Publication 1715-UM001J-EN-P - December 2020 193
Chapter 6 Configure the Redundant I/O System
7. Click the Connection tab, see page 169.
8. Click the Module Info A tab, see page 171
.
9. Click the Configuration tab, see page 191
.
10. Click OK.
The I/O configuration folder of your project now looks similar to this.
1715-OF8I Analog Output
Module
Add the Analog Output Module to the project
In this section, you do the following:
• Add a 1715-OF8I analog output module in Duplex mode to the project.
• Add a 1715-OF8I analog output module in Simplex mode to the project
Step 1: Add the Analog Output Module in Duplex Mode
1. Add the new module, see page 177.
The Select New Module dialog box appears.