34 Rockwell Automation Publication 1715-UM001J-EN-P - December 2020
Chapter 2 Installation Instructions
Multi-point Network Communication Connections
Field-side Power
Removal and Insertion Under Power (RIUP) Fuses
WARNING: If you connect or disconnect the communication cable with power applied to this module or any device on the
network, an electrical arc can occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
WARNING: If you connect or disconnect wiring while the field-wire power is on, an electrical arc can occur. This could
cause an explosion in hazardous location installations. Be sure that power is removed or the area is nonhazardous before
proceeding.
WARNING: If you insert or remove a base unit or termination assembly while power is applied, an electrical arc can occur.
This could cause an explosion in hazardous location installations.
Be sure that power is removed before proceeding.
WARNING: Do not remove or replace fuses when energized. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
To Next Page
Loading...
