Rockwell Automation Allen-Bradley 1715-OB8DE - 1715-N2 T and 1715-N2 S Slot Filler Covers; Power Requirements

50 Rockwell Automation Publication 1715-UM001J-EN-P - December 2020
Chapter 2 Installation Instructions
1715-N2T and 1715-N2S Slot Filler Covers
Slot filler covers are available in two sizes to cover empty slots in your system.
Use the tall cover (catalog number 1715-N2T) when no termination assembly is
present. Use the short cover (catalog number 1715-N2S) when a slot has a
termination assembly, but no module.
Power Requirements
A 24V DC power supplied is required. See Install the Power Supply on page 60
for complete details.
32086 M
CH1
CH1
CH1
CH1
CH1
CH1
CH1
CH1
TERMINAL IDENTITY
AOTA
Dual.
Ethernet 1
Ethernet 2
Reset
Ethernet 1
Ethernet 2
Reset
Rack Status
Module Status
Redundancy Status
Network Status
Rack Status
Module Status
Redundancy Status
Network Status
Slot Filler Covers
32078 M
ATTENTION: To comply with the CE Low Voltage Directive (LVD), all
connections to this equipment must be powered from a source
compliant with the following:
• Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV)