Rockwell Automation Allen-Bradley 1794-IB16D - Chapter 5: FLEX I;O on DeviceNet Network

Rockwell Automation Publication 1794-UM061B-EN-P - March 2020 49
Chapter 5
Configure FLEX I/O Digital Modules on a
DeviceNet Network
How to Use This Chapter
This chapter provides basic information on how to use a 1794-ADN FLEX I/O
adapter to connect 1794 FLEX I/O digital modules to a DeviceNet network.
Use RSNetWorx™ for DeviceNet software to add the 1794-ADN DeviceNet
adapter and FLEX I/O modules on a DeviceNet network.
To use the FLEX I/O adapter, cat. no. 1794-ADN:
Topic See Page
How to Use This Chapter 49
Add the Scanner to the I/O Configuration of
the Controller Using RSLogix 5000 Software
50
Determine the Address of DeviceNet Data 54
Tally Memory Requirements 56
If You Configure the Adapter Offline 57
Set the Address of the Adapter 58
Step: Page:
❑ Tally Memory Requirements 56
❑ As an option, give each module its own memory location (DINTs)
within the scanner. This may make your programming easier. Assign
one address for the 1794-ADN and all modules that you connect to it.
56
❑ If You Configure the Adapter Offline 57
❑ Set the Address of the Adapter 58