Rockwell Automation Publication 440G-UM001B-EN-P - May 2016 39
Description of Operation Chapter 4
1. Undo locking screw.
2. Lift locking arm using a screwdriver and actuate the guard door handle.
Figure 3 - Auxiliary/Manual Release
IMPORTANT The mechanical release is not a safety function.
The machine manufacturer must select and use a suitable release according
to the risk assessment.
The correct function must be checked at regular intervals.
ATTENTION: The locking screw must be screwed back in and sealed after
assembly and after use of the manual release (for example, with sealing
lacquer). Tightening torque is 0.5 Nm.
To Next Page
Loading...
