16 Rockwell Automation Publication 750-IN119A-EN-P - April 2022
Chapter 1 Product Overview
Hardware Installation
Diagrams
The assembly illustrations throughout this manual contain diagrams as shown
here. These diagrams identify the corresponding sequence number when
required, type of fastener, fastener size, tool type and size, and final assembly
torque.
Configuration Tool Options Any of the following configuration tools can be used with PowerFlex 755TS
products.
• PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM
See the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM (Human Interface
Module) User Manual, publication 20HIM-UM001
.
• Connected Components Workbench™ (CCW) software R13.00 or later
• Connected Components Workbench is the standalone software tool for
use with PowerFlex drives. You can obtain a free copy by Internet
download at the Product Compatibility and Download Center rok.auto/
pcdc
• Controller configuration software, such as RSLogix 5000® software,
version 20.00 or later, or Studio 5000™ Logix Designer application,
version 21.00 and later.
• Automatic Device Configuration (ADC), an RSLogix 5000 software
feature, which supports the automatic download of configuration data.
The download occurs after the Logix controller establishes an EtherNet/
IP network connection to a PowerFlex 755TS product and its associated
peripherals.
• A computer connection to the EtherNet/IP network.
1
M4 x 10 mm
T20 or F - 6.4 mm (0.25 in.)
4.8 N
•m (42 lb•in)
Fastener Type
Flat-head screw
Hexagonal bolt
Hexagonal nut or standoff
Hexagonal screw
Hexalobular (star or Torx) screw
Phillips screw
Pozidriv screw
Slotted hexalobular (star or Torx)
screw
Corresponding
Sequence
Number
Tool Type and Size
F Flat-nose screwdriver
Px Phillips screwdriver/bit and size
PZx Pozidriv screwdriver/bit and size
Txx Torx screwdriver/bit and size
xx mm Hexagonal socket wrench
Final Assembly Torque
Fastener Size
To Next Page
Loading...
