Rockwell Automation Publication 750-IN119A-EN-P - April 2022 53
Chapter 4 Mechanical and Electrical Installation
Figure 33 - Enclosure Code N (IP00, NEMA/UL Open Type) Wall Mount, Frames 6 and 7
To remove or replace the cover, use this tool:
• Recommended screwdriver = 9.5 mm (0.375 in.) flat
Figure 34 - Enclosure Code N (IP00, NEMA/UL Open Type) Wall Mount, Frames 6 and 7 Access Door
To open or secure the access door, use this tool:
Recommended screwdriver = 6.4 mm (0.25 in.) flat or T20 Hexalobular.
Hardware Connections The human interface module, internal power devices, and option module
hardware connections are made in the control pod. The host drive and
embedded functions are assigned fixed port numbers that cannot be changed.
Option modules are assigned a port number that is based on where they are
installed.
To Next Page
Loading...
