52 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 3 Setup and Commands
How to Configure the PowerMonitor 5000 Unit
From any power monitor web page, click the Configuration folder. A list of
available configuration pages is displayed in the tree. The steps to enter, edit, and
apply configuration parameters are similar for each configuration page. The
configuration parameters and their properties are described in the following
chapters:
• Chapter 4
, Metering.
• Chapter 5
Power Quality Monitoring
• Chapter 6 Logging
• Chapter 7 Logic Functions
• Chapter 8 Other Functions
The configuration pages contain text boxes to enter parameter values, pull-down
menus for selecting enumerated parameter values, and an Apply Changes button
to apply changes to the power monitor. The power monitor checks that
parameter values are within their valid range before applying them. A dialog box
appears to report the success or reason for failure of an attempt to apply new
parameters.
Basic Metering Setup
Follow these steps to configure the basic metering parameters.
1. Click the Metering_Basic page under the open Configuration folder.
This page displays the existing basic metering configuration of the power
monitor, including the metering mode, PT (VT), and CT ratios, nominal
voltage and frequency, and demand.
You can select other configuration pages by clicking the desired page in the
tree, or by clicking the corresponding tab in the page.
2. To change the basic metering setup, enter the desired values into the text
boxes, scroll down, and click Apply Changes.
A dialog box appears to report the result of the setup change.
To Next Page
Loading...
