Safety
Regulatory Compliance
28 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
Regulatory Compliance
The MagneMotion node controllers are CE-compliant. To determine if a
specific node controller is CE-compliant, check for the CE marking on the
component. If necessary, request the official Declaration of Conformity
(DoC) from MagneMotion.
The MagneMotion node controllers are UL Recognized in Canada and the
United States. To determine if a specific node controller is UL Recognized,
check for the UL Recognized Mark on the component. Some examples of
the Mark may not display the ‘C’ and ‘US’.
Other sections of this manual may include additional regulatory information. These compo-
nents comply with the regulations from the organizations that are indicated in Table 2-1.
Equipment Regulatory Guidelines
The following regulatory guidelines are provided to aid in the use and service of the Magne-
Motion node controllers in a transport system.
• ICT Customer Support issues Technical Advisories to notify the owners of record of
any field retrofits.
• Contact ICT Customer Support for information regarding repair and maintenance ser-
vice policies, both during the production of the node controllers and after production is
discontinued.
• Any user-caused damage during integration of the node controllers into their equip-
ment is the responsibility of the user.
Table 2-1: Regulatory Information
Organization Regulations
CE (Conformité Européenne) – The European
safety requirements
• Machinery Directive
• Low Voltage Directive
• EMC Directive
UL • 61010-1
NOTICE
It is the responsibility of the end user/third party integrator to make sure that
the installed node controllers comply with the appropriate facility, local, and
national regulations.
To Next Page
Loading...
