Rockwell Automation MagneMotion 700-0871-00 - NC-S Mounting Plate; NC-S Mounting Plate Mechanical Drawing

Specifications and Site Requirements
Mechanical Specifications
Node Controller Hardware User Manual 55
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
NC-S Mounting Plate
Two mounting plates can be used for mounting the NC-S node controller to any flat surface.
Figure 4-2: NC-S Mounting Plate Mechanical Drawing
NOTE: Contact ICT Customer Support for current detail drawings.
Exposed Materials
• 5052-H32 Aluminum.
• Epoxy powder coat paint.
All Dimensions in Millimeters [Inches]
[0.487]
12.37
[0.217]
5.50
[1.181]
30.00
[1.346]
34.20
[0.064]
1.63
3X
[0.486]
12.35
3X
[6.692]
170.00
[6.102]
155.00
2X
[3.346]
85.00
2X
[0.591]
15.00
2X
0
0
0
3X
[0.217]
5.50
3X
THK