Installation
Unpacking and Inspection
86 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
Unpacking and Inspection
The node controllers are shipped in separate packages. Open each package carefully following
the steps that are provided in Unpacking and Moving on page 86; inspect and verify the con-
tents against the shipping documents. Report any damage or missing items immediately to the
shipper and to MagneMotion.
One set of shipping documents is attached to the outside of the main shipping crate for easy
access.
NOTE: The number and contents of the shipping packages depends on the items that are pur-
chased and their configuration (that is, shipped as components or shipped as a sys-
tem). See the shipping documents for the exact contents. Table 5-1, is an example
and is provided for reference only.
Unpacking and Moving
The node controller arrives from the factory as an individual component ready for final instal-
lation. The information required to install the node controllers is provided in Node Controller
Installation on page 87.
NOTE: Save the shipping packaging for possible future use. If the node controllers are
shipped, the original shipping packaging must be used. If the original packaging has
become lost or damaged, contact MagneMotion for replacements.
1. Upon receiving the packages, visually verify that the packaging is not damaged.
Inform the freight carrier and MagneMotion of any inspection discrepancy.
2. Open each shipping package and verify the contents against the shipping documents.
Do not remove any protective wrapping.
3. Carefully inspect each package for signs of shipping damage. Report any damage
immediately to the shipper and to MagneMotion.
4. Move all items to their destination (see Node Controller Installation on page 87).
Table 5-1: Node Controller Packing Checklist Reference
Package Contents
NC-S Node Controller • Node controller.
NC-E Node Controller • Node controller.
• Miscellaneous hardware.
NC-12 Node Controller • Node controller.
NC LITE Node Controller • Node controller.
• Power supply.
• Miscellaneous hardware.
• Cables.
To Next Page
Loading...
