Rockwell Automation Reliance SP500 - Appendix D Compliance with Machinery Safety Standard EN-60204-1:1992

Compliance with Machinery Safety Standard EN-60204-1:1992 D-1
APPENDIX D
Compliance with Machinery Safety
Standard EN-60204-1:1992
The SP500 AC Speed Controller for Electric Motors complies with the following
sections of Machinery Safety Standard EN-60204-1:1992.
EN-60204-1
Section Title
6 Protection against electrical shock
6.2.1
- Protection by enclosure
6.2.3
- Protection against residual voltages
6.3.1
- Protection by automatic disconnect of supply
6.4
- Protection by the use of PELV (Protective Extra Low Voltage)
7 Protection of equipment
7.2
- Overcurrent protection
7.2.3
- Control circuits
7.2.6
- Transformers
7.5
- Protection against supply interruption or voltage reduction and subsequent restoration
8 Equipotential bonding
8.2.1
- General (the PE terminal)
8.2.2
- Protective conductors (connection points)
8.2.3
- Continuity of the protective bonding circuit
8.2.7
- Protective conductor connecting points
8.3
- Bonding of the protective bonding circuit for operational purposes
8.4
- Insulation failures
8.5
- Bonding to a common reference potential
8.6
- Electrical interferences
9 Control circuit and control functions
9.1.1
- Control circuit supply
9.1.3
- Protection
9.1.4
- Connection of control devices
9.2
- Control functions
9.2.1
- Start function
9.2.2
- Stop function
9.2.3
- Operating modes
9.2.5
- Operation
9.2.5.3
- Stop
9.2.5.6
- Hold-to-run controls
9.2.6
- Combined start and stop controls