Only program on one of the programming tracks completely separated from the other hardware, in order
to avoid an inadvertant programming of other decoders. You will be able to program everything on the
hardware, up to the local addresses (CV1 or CV17+18), in the case of a digital control, such as the ROCO
multi
MAUS, which has command of the ‘POM’ Mode.
Pay attention to the Tables in Fig 2 on page 17.
CV use def.setting bandwith of possible changes
01 locomotive address 03 01 – 99
02 minimum speed 03 01 – 63
03 time of acceleration 08 00 – 63
04 time of braking 06 00 – 63
05 maximum speed 64 00 – 63
07 Version of the decoder only reading!
08
Manufacturer‘s identification or
return to default settings
151 only reading / reset to factory values = 08
29
Setting of speed steps, analogue
mode, driving direction: NMRA
06
Bit 0 driving direction: 0 = normal,
1 = reversed
Bit 1 speed steps: 0 = 14, 1 = 28/128
Bit 2 analogue mode: 0 = aus, 1 = ein
49 load regulation 01 01 = on / 00 = off
63 Dimmer for all function-outputs 07 00 – 07
To Next Page
Loading...
