Roger Technology B70/2ML - Page 22

EN
53
4 Technical characteristics of product
B70/2ML B70/2ML/115
MAINS POWER VOLTAGE 230 Vac ± 10% 50 Hz :EGr,^
MAXIMUM MAINS POWER ABSORPTION 150 W
INRUSH POWER 350 W
FUSES
F1 = F3.15A (5x20 mm) accessories power supply protection
F2 = F15A (5x20 mm) engines power circuit protection
F3 = T1A (5x20 mm) Primary transformer protection
CONNECTABLE MOTORS 2
MOTOR POWER SUPPLY 24 Vac
MOTOR TYPE sinusoidal drive brushless (ROGER BRUSHLESS)
MOTOR CONTROL TYPE WIRWSVPIWWƼIPHSVMIRXIHGSRXVSP*3'
RATED MOTOR POWER 40 W
MAXIMUM MOTOR POWER 110 W
MAXIMUM POWER, FLASHING LIGHT 25 W (24 Vdc)
FLASHING LIGHT DUTY CYCLE 50%
MAXIMUM POWER 100 W 230 V
;:  (potential free contact)
GATE OPEN LIGHT POWER 3 W 24 V
ELECTRIC LOCK POWER 15 W 12 V (medium voltage) (*)
MAXIMUM ACCESSORY CURRENT
ABSORPTION
10 W 24 V
(400 mA)
OPERATING TEMPERATURE
q' q'
DEGREE OF PROTECTION IP54
PRODUCT DIMENSION dimensions in mm 112x175;IMKLXOK
(*) The electric lock output provides a voltage of 24Vdc nominal (max 30Vdc) modulated to 50% (50% ON, 50% OFF).
The device to be connected must therefore be able to withstand a maximum voltage of 30Vdc.
The total of the absorption values of all the accessories connected must not exceed the maximum power
values shown in the table. The values are guaranteed with original ROGER TECHNOLOGY accessories ONLY.
8LIYWISJRSRSVMKMREPEGGIWWSVMIWQE]PIEHXSQEPJYRGXMSRMRK63+)68)',2303+=HIGPMRIWEPPVIWTSRWMFMPMX]
JSVMRGSVVIGXSVRSRGSRJSVQMRKMRWXEPPEXMSRW
All the connections are protected by fuses (refer to the table). The courtesy light requires an external fuse.