Roger Technology H85/TDR/E - Advanced Receiver Integration and Code Management; Learning Procedure for Multi-Channel Receivers; Troubleshooting Receiver Learning; Deleting a User Code

2) Key in 5555*B (This enters your user entry code, and opens the gates
pedestrian function)
Learning Procedure - Roger control box or standalone receiver.
(The keypad learns in the same way that your learn the gate remotes, refer to
the control box instructions)
1) Press P1 on the radio card the led will flash slowly.
1) Then key in 5555*A (This enters your user entry code 5555*A into the
receiver channel 1)
1) Press P2 on the radio card the led will flash slowly.
1) Then key in 5555*B (This enters your user entry code 5555*B into the
receiver channel 2)
Troubleshooting
If the unit does not learn to the receiver, try speeding up the process as the
receiver may have timed out. Or when entering the code 5555*A or B hold the
second A or B for longer (This is the same as holding your remote button
longer).
Deleting a user code. (Example – user code 5555)
1) Key in ##5555* (This enters the user code 5555 that you wish to delete)
2) If the code exists the red led flashes and stays lit.
3) Key in 5555*(The user code 5555 is deleted, the green led lights and the unit
buzzes for two seconds