Need help?Do you have a question about the Roger GPSR-1-EU and is the answer not in the manual?
Control the output signal level (gain variation 0 to -40dB) of the GPS repeater.
Input for repeater power supply, reverse polarity protected.
Connects outdoor antenna to SMA input on the repeater front panel.
Visual indicator for repeater operational status.
Internal antenna for re-radiating GNSS signals.
Explains the meaning of different LED light patterns for normal and error states.
Provides solutions for common problems like gain setting issues.
Boosts GNSS signal for longer cable runs or splitting to multiple repeaters.
Combines amplification and splitting for multiple repeater units.
Distributes a single antenna signal to up to five repeaters.
Distributes a single antenna signal to up to two repeaters.
Control the output signal level (gain variation 0 to -40dB) of the GPS repeater.
Input for repeater power supply, reverse polarity protected.
Connects outdoor antenna to SMA input on the repeater front panel.
Visual indicator for repeater operational status.
Internal antenna for re-radiating GNSS signals.
Explains the meaning of different LED light patterns for normal and error states.
Provides solutions for common problems like gain setting issues.
Boosts GNSS signal for longer cable runs or splitting to multiple repeaters.
Combines amplification and splitting for multiple repeater units.
Distributes a single antenna signal to up to five repeaters.
Distributes a single antenna signal to up to two repeaters.
To Next Page
General