V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Control and Display Elements
Five pushbuttons
with protective
caps
(6 ¥ 10.5 mm)
Description
By actuating key MENU either a pro>
gramming process is terminated or the
program returns to the next higher level
(see 3.1.4).
If e.g. in the softkey assignment field (14)
the programming menu is displayed, the
program returns to the scanning menu by
actuation of the MENU key. Pressing the
MENU key once more calls up the main
menu.
The softkeys receive their respective
functions via the softkey assignment field
(14).
Via the softkeys the operator moves from
the highest (see 3.1.4) to the lowest level.
In order to move from a lower to the next
higher level, the operator has only to
actuate key MENU (15).
If the toggle switch is in the upper
position, the AF signal is fed from the out>
put of the AF amplifier in the control unit
to the loudspeaker (13).
By means of the AF control (18) the
volume can be adjusted, as required.
By means of the AF control the volume of
a loudspeaker or headphones to be con>
nected at the interface (see A2.1) can be
adjusted.
Control turned fully counter>clockwise:
low volume
Control turned fully clockwise:
high volume
For
R&S EK 896 only:
Via the AF control the volume of that AF
signal is set, that is emitted by the loud>
speaker (13) depending on the position of
the toggle switch (17).
Control or display
element
DesignNo.
15
16
17
18
MENU
Yellow push>
button with
protective cap
(6 ¥ 10.5 mm)
1>way toggle
switch
AF
Variable resistor
with rotary knob
control span
270∞
Note:
After pressing key MENU on the highest level,
the modulation mode and control type will be
displayed for 3 s, if setting dBoV or dS is selected
(see 3.1.18.15 or 3.1.21.8).
6164.0717.02_01
> 3.81 >
To Next Page
Loading...
