A5. Remote Control Software
For the VLF>HF receiver the Remote Control Software R&S EK 895S2 is available
on special order under the order number 6073.2260.02.
Stored on a 3Ω∫ program disk, it offers a high convenience for remote control of
the EK!895. The program disk contains the following files:
f EK895.EXE
f EK895.DOC
f README.BAT
This program can be used provided that the following requirements are met:
f IBM>AT compatible PC with
> RS 232C interface (COM1 or COM2),
> 3Ω∫ disk drive and
> MS DOS in version 3.0 or above.
f Connecting cable (zero modem, see figure below)
Short>circuits
Z
Z
Z
Z
Z
Z
Z
Z
Z
.1
RxD .2
TxD .3
DTR .4
GND .5
DSR .6
RTS .7
CTS .8
.9
[
[
[
[
[
[
[
[
[
.1
.2 TxD
.3 RxD
.4
.5
.6
.7 GND
.8
.9
Case
Case
COM 1 or COM 2
(PC, 9>way Plug)
RS 232C > RS 485 Interface
(25>way Plug)
For starting the remote control software proceed as follows:
1. Switch on computer and, if required, associated monitor.
2. Insert appropriate program disk into disk drive.
3. On hard disk create directory EK895.
4. Copy files from program disk into EK895 directory.
5. Open directory EK895.
6. Start software by actuating the ENTER key.
The DOC file may be viewed after entry of the command READ.ME.
6164.0717.02_01
> A5.1 >
To Next Page
Loading...
