R&S
®
CMW 500 Command Reference
Instrument-Control Commands
Operating Manual 1202.3986.32 – 03 121
Example See
CONFigure:SELFtest:REFerence:FREQuency:SOURce
Characteristics Firmware version V1.00
6.3.3 STATus Commands
The STATus subsystem controls the SCPI-defined status reporting structures. The
purpose and definition of status registers is given in Chapter 5, section Status
Reporting System. Unless otherwise stated, all of the following commands are SCPI-
confirmed.
Note that *RST does not influence the status registers.
STATus:OPERation:CONDition?
Returns the contents of the CONDition part of the status register. Reading the
CONDition registers is nondestructive.
SCPI Confirmed, query only
Example STAT:OPER:COND?
Query the CONDition part of the OPERation register to check for
states which are part of the instrument's normal operation.
Characteristics Firmware version V1.00
*RST value: –
STATus:OPERation:ENABle <NRf>
Sets the enable mask which allows true conditions in the EVENt part of the status
register to be reported in the summary bit. If a bit is 1 in the enable register and its
associated event bit transitions to true, a positive transition will occur in the summary
bit (bit 3 of the STatus Byte).
SCPI Confirmed, command or query
<NRf> 0 to 65535 (decimal representation)
Def. value: – (See also Reset Values at the end of the "Remote
Control" chapter)
Example STAT:QUES:ENAB 1536
Set bits no. 9 and 10 of the OPERation:ENABle register (see
decimal representation of a bit pattern).
Characteristics Firmware version V1.00
To Next Page
Loading...
