Rohde & Schwarz CMW 500 - Page 142

R&S
®
CMW 500 Command Reference
Instrument-Control Commands
Operating Manual 1202.3986.32 – 03 122
STATus:OPERation[:EVENt]?
Returns the contents of the EVENt part of the status register. Reading an EVENt
register clears it.
SCPI Confirmed, query only
Example STAT:QUES?
Query the EVENt part of the OPERation register to check
whether an event has occurred since the last reading.
Characteristics Firmware version V1.00
*RST value: –
STATus:OPERation:NTRansition <NRf>
Sets the negative transition filter. If a bit is set, a 1 to 0 transition in the corresponding
bit of the associated condition register causes a 1 to be written in the associated bit of
the corresponding event register.
SCPI Confirmed, command or query
<NRf> 0 to 65535 (decimal representation)
Def. value: – (See also Reset Values at the end of the "Remote
Control" chapter)
Example STAT:QUES:NTR 1536
Set bits no. 9 and 10 of the OPERation:NTRansition register
(see decimal representation of a bit pattern).
Characteristics Firmware version V1.00
STATus:OPERation:PTRansition? <NRf>
Sets the positive transition filter. If a bit is set, a 0 to 1 transition in the corresponding
bit of the associated condition register causes a 1 to be written in the associated bit of
the corresponding event register.
SCPI Confirmed, command or query
<NRf> 0 to 65535 (decimal representation)
Def. value: – (See also Reset Values at the end of the "Remote
Control" chapter)
Example STAT:QUES:PTR 1536
Set bits no. 9 and 10 of the OPERation:PTRansition register
(see decimal representation of a bit pattern).
Characteristics Firmware version V1.00
深圳德标仪器 135-1095-0799